Thanks Brian , I will be in touch
Hi There Has anyone on here fitted the quiet baffles in freedom sharp curve radius. I have recently install ...
i use a K&P on my dragracing Dyna only because i can check in side every time to see whats going on or if anything is coming o ...
well you got it sorted so all good but I don't know why it was stubborn for you, with torch in one hand and pick in the other mine ...
Yes, and really!!? Bugger.... Still, Evo's don't break.....right?
Hi SSML ... yeah went through the procedure I mentioned and everything turned out fine ... weird how the manual doesn't mention it ...
I had the same problem wth mine and I took out the bolt -give it a good clean then put it back in with a bit of sealer . So ...
Change inner cam bearings check tensioner shoes for wear replace if required and ride
Hi Binnsy, There are 2 ways to have a Power Vision. The 1st is to buy your own module. (Rec retail $590 ) The 2nd way is buy a ...
Nothing that I can see, it's a 103 cal, injectors are right for your model, by set up I ment getting the VE's dialed in ie smart t ...
Thanks locks, much appreciated mate! i didn't realise that you had to drill out the damper tubes holes as well.... Thanks.& ...
Just wondering do we need T45, T47 or T50 of the Torx drivers for our Harleys? Was fitting the engine guard bar last night. My ...
Hi Daggs. I think in the end simplicity and a bit of cost thrown in the mix. No mucking around with dyno etc. and they ...
2006/2007 Turboed Night Rod for $24,500 http://www.ebay.com.au/itm/harley-davidson-nightrod-vrod-custom-turbo-v-rod-night-rod-s ...
front turn signal relo going to use the fork mount ones but want to know if all the electrics have to be pulled out of the switch ...
yes they can be installed on another sporty providing it is for a model which that device was made for, they are not like Harley s ...
8yrs my battery lasted 2008 -2014 fatty an 2 yrs stg iv use an orig batt an i thought was suspect last coupla yrs but finally no g ...
if you have da heads off then strip da valve's out clean with a wire drill brush & kero finish with a scrower drill pad &a ...
1
