I'll have to agree with Krash. If you keep engine relatively stock, then just make sure the crank run-out is 0.003" or less & repl ...
I have removed the o2 censors completely off my fxst that runs a power commander v My mechanic had no probs tuning it with the la ...
Not normal, regulator is faulty, if it'e charging 17.25 to 18.5 volts at idle, what.s it letting through at higher revs ? ...
wonder if any one is using a V&H Pro Pipe and has the competition baffle in it and could take a picture and post it on here so ...
Yeh it was an extreme move but I figured it was time to upgrade. I pick the new bike up at the end of July and will let ya know ho ...
When setting up a AFR table is there any benefit smoothing the table eg 30kpa column 2500 revs 14.2, 3000 revs 13.6, 3500 rev ...
Thanks Guys I know what your saying Daggs and dont disagree at all; just cant get it done at this time. The little freeloaders a ...
Quite possible something is leaking inside the tank from when you changed the bits over. The output hose inside the tank has a gr ...
Try http://capital.hdspares.com.au/ Gives prices in aussie dollars
I normally use paint stripper and the pressure washer to remove clear coat.
ok cheers will do
Going buy that pick would say it's mounted wear the lower splash guard bolts to on the swing arm four mounting holes on a evo swi ...
I have cracked , a lot of coil brakets on Harleys over the years think i cracked one on a 2001 Dyna also cracked belt gard, ...
Cool mate, I'm pretty sure you'll come away happy, the man knows his shit!
Thanks for your imput lads ,,, When I'm in the cam chest , I'll check the cam plate and oil pump and see if I will reuse them, a ...
Not Sure about BDL cover, But i made my own when i ran a three inch open belt primary on a Shovel it bolted on. mine still doing t ...
That's what I think I'll do. Copy over the richer AFR's and test. My lasy 4 vtune looked good, no knock at all.
G'day fellas. I'm new to the Forum but have a question only someone who has done a lot of work on old 1340's would ...
read on the net if you drill hole in the end it give good midde ground between standard and the quiets - quiets seem to muffled
Thanks champ.
