Latest comments

i think and they are powder coated by the factory

Intake came with a K&N filter and a rain sock too

Ah yeah I get ya. Been doing a bit of research on them. I really appreciate you sharing your knowledge, always wanting to learn mo ...

Yep same here on a mirror I tried that trick on rivets not screws But I ended up chipping my glass so got a new take off set Of ...

Thanks for the pointers, At this Stage it looks like a visit to one of the shops in albury might be the go.....

Thanks for the replies. I notice the pads are down a bit and wondering if maybe thats the cause of the brake light issue. I woul ...

Just want to start this topic Any good mechanic around NSW south west

Ditto on my 86 FXR... needle bearing to support the starter shaft is in the outer primary.

Thanks Hoodeng for the advice , the bike is a sand drag bike , will be racing this weekend so will see what it is like on the trac ...

double posted for some reason

this forum is for efi and tuning related posts so you may not get many reponses here, I did a quick search and there is some good ...

Thanks

Compensator ??

All sorted.

da bolts had cum a bit loose for that to happen , tilt bike over as far as too da left & spray cleaner into da g/box area & ...

speedzter thanks for that link , ive dont plenty of searching uder the Edelbrock part number but WPSracing are using there own num ...

replace the coil , may be able to solder as a temporay fix but not worth the bullshit if it falls off miles from home

Thanks for the tips, I guess I wasn't paying enough attention when I tightened up after the change, all sorted now!

I've checked my workshop manual and as I thought it isn't a sealed unit but comes apart. I'm just going to have to CSI my way thro ...

Never had an issue. Grease on the inside of the exhaust port and a bit on the gasket. or buy some copper crush gaskets... stil ...