This is a old thread ,, and very technical to !!!! Date of OP's question is 20th June 2015 .. I would say, he has'nt had a h ...
Thundermax is sending over a new or repaired unit. Will keep you updated when we re-install it. Cheers
From memory there is some change between 2007 and 2008 onwards. Sorry I can't be more specific mate I just remember that from w ...
I have just discovered what I think may be what you are describing on my Roady . I have reasoned out that when I roll back after s ...
Merry Xmas gents, thanks for your input! Hope you all have a great day tomorrow with family, friends, pets or whatever you're i ...
Had similar was battery terminal bolt bottomed out tight but washer missing did strange things at various re ...
stage 4 in my fatbob. 60,000 ks with out missing a beat. Carted me, the missis and a heap of luggage the full circle of Aus. Abso ...
you could pop the inspection plate and have a look, then adjust chain if needed.
Thanks Hilly, Yes make a lot of sense to to start at 140mm, these forks are quite easy to add to if needed. The guys I ...
Hilly I don't think you could remove the Cat but anything is possible? also I am unsure how far the cat goes? it is near the e ...
Thanks fellas. I'll go get it sorted. Cheers. Bucky
Ive had a change of mind, so its been Deleted showing this is probably not a good thing .cause of all the low life thieving s ...
My pads started squeeling when wet and the mech shoved some red goo (came from supercheap) on the back and all was good. He said ...
Sorry Hydroduck and others for throwing a spanner in the works but It's better to find out sooner than when it's too late. I co ...
Think having compression damping better no matter what you are doing. you would feel the difference!!!
PM sent
Thanks Dave and my CV carb has a chrome top with "Harely Davidson Motorcycle Company" impressed into it in a circle on the top, an ...
Thanks for the replies. Was just thinking what the next step to take was to produce more power/torque FUN!!! I was thinking if the ...
look forward to hearing your opinion on the AE tyre Retroman My rear tyre is due for replacement and was looking at them but ve ...
Use a socket (deep socket if needed) and long breaker bar rather than a wrench
