Moving up to a big twin might be the go
...
at a guess i'd say your primary piston cup [ seal] is passing fluid back behind it so no level loss and usually no visible leaks,b ...
I'll try and find Dyno sheet and see if I can load them up
Look good. Well done.
Chill mate, I didnt see the bit about the stone. Glad you got it sorted.
I like Trease Cases the best & Australian made i have seen some new old stock Trease cases at a workshop in Sydney. but ...
Hey guys, any thoughts on the zippers chain conversion kit??Claims to allow 180 tyre without changing swingarm?. Cheap also at onl ...
cp pistons , s/s 585 cams hpi 55 throttle body , heads done in house , 1.900 intak ...
96 cub softail to s/s 107 build ,crane cam , hpi 55 throttle body ...
Just ordered this Danny grey seat so thing are moving along
It will happen if you put to much oil in the oil tank.
I remember when had my 2006 Fatboy at the time of release of Injectors 8 or 25 .. Had a win, mine were 25 degrees.
So we got both FP3's installed and ran about 500km on both with auto tune turned on, flashed the new values and I have to say that ...
Found this on the USA forum......'My siren used to chirp 2 times when I turned the ignition off. Now it ...
Tru_Speed instruments in Guildford mate. Though I suspect what the boys have already said, the sensor is rooted. They are cheap en ...
Mate, easily changed, there are conversion bearings available....though I will mention that some Harley wheel bearings are proprei ...
Hi Guys,I am looking at doing a 110 build on my breakout using either the s&s or HD bolt in cylinders.other specs fueling ...
Hey MateCall Jim on 0409 396 441, he tunes for LA Cycles at Hoxton Park, tell him ...
About to change my Twin Cam 88 primary cover gasket because it's developed a small leak. I bought a James gasket with the sil ...
