all good mate I'm glad you got it sorted.I won't go too deep into the story, but I had the same issues with my FXDLS. Together wit ...
I recently fitted Andrews 48H to my stock 96 Softail ( S&S slip ons, K&N SE air cleaner, TTS tuner) when I changed m ...
Hylomar all the time!
Krash, not saying it doesnt happen but Ive had loads of big cube HC motors come thru my shop and Ive never seen a ring gear issue. ...
Yes, I was going to ask that the welder purged the pipe and then TIG'd as opposed to MIG'd (MIG is more brittle than TIG, although ...
G'day,Awsome weekend weather here in the south west. After a 30 min ride, just about home and the little red light comes on the in ...
I don't know of any that are aussie made however you can cobble togetehr something with parts (depending on what model you're ridi ...
new seals & pistons in and so far so good on the bike lift the rear wheel turns freely, apply brake & release and wheel tu ...
the discs we use for gasket removal and rust removal are 50 mm diameter with a 1/2 turn lock on to the drive pad,the air tool is s ...
Thanks Hilly
Hey Mate,Yes I am doing an upgrade on the cheap..I bought myself a 110 bolton kit for my 103and while I was at it I went the S& ...
Rep from 3M had this to show me Re: bonding 3M tape to itself. This is 3M VHB apecifically designed for auto trims.2 days it was b ...
It's the whole lot new in the box
I have seen multiple bikes now where the original race tuner follows a different life's path to the bike.They get "lost" all the t ...
I like to loosen the cover on the master cylinder and break the seal on the rubber cover as well, to assist the escape of the air ...
a few years back i got some mini apes with risers off a softail for $100 and put them on myself on my 93 lowrider. at the time it ...
So the lowers for 41mm forks are interchangeable yeah ???
Hi There does anybody know if the Arlen ness 10 Gauge primary covers will fit 103ci Dyna Fat bob? I checked their website and it s ...
I’m no expert either but here goes. The lower rockers that house the axle always run under horizontal that is slightly up at the f ...
thanks Steamer will check out bike skate but will probably have a go at making one myself
