Hi Guys, i have recently bought an 09 dyna lowrider to keep an S4R Monster company but have the shits cos the termis are l ...
ok looking to find a good pc111 dynotuner in melb any area just want to here good or bad referrals ?? cheers............
hi all , i have just gotten my custom softail (was 1995 heritage) on the road after building it over the last 9 months a ...
hey mate i had the same problem , if you msg walka (ian from VPW) he sent me a photo of a round oil tank cut in half , however i c ...
thanks fellas i will fill it from inspection cover but i might have to take derby cover off anyway to adjust the primary chain or ...
I don.t think there is much that will get scraches out of chrome....... One thing I have learnt the hard way is to be very carefu ...
Went out into the hills today and did another data run will post up the maps later.
Hi Kiteman, I have had my ecu light come on lately sice loading new map, it seems to come on when engine is running extremely ho ...
Sorry for the delay busy as at the moment.......cant help you ...every thing was disconnected on my bike from new..........self ta ...
I got mine on today and yeah not to bad on the installation. I will have to see how things go when the heat hits. But it is more ...
Hope someone can advise me. I bought a set of apes that came with a braided clutch cable (Barnett) I want to fit it to m ...
does anyone have a good map for a 08 96 dyna with 2into 1 vance and hines and high flow aircleaner 403 map seems to be runni ...
Climax hand controls Sounds like a wank...
Posted By Ozroder on 21 Nov 2009 5:58 PM The Jims bearings will be torringtons........................Ozroder Thanks for the ...
hi, when you take of the clutch release cover for any reason you should readjust the clutch proper . back the cable then rea ...
hi, if the comp or big bore + cams ain't big enough it will just sound like the bike next door ,
Thanks Scotty...I will replace them. (Before I go for a blat to the Upper Yarra Dam)
Its running strong and good i think Speedzster, I didnt quite get to 180 lol about 150 with plenty of pull left, its the poppi ...
Update: I pulled the pushrods yeterday & found small marks on top of 3 pushrods & inside the tubes, machined 0.4mm out of the ...
Scotty, you're a very smart fella. This forum would be lost without your valued input.
