Ok......
I recently purchased a round oil tank to replace my horse shoe factory one on my EVO.
My problem arises in the face that I had my brother pull the horse shoe out, in his flash of brilliance he pulled the hoses off the oil tank leaving me with no idea as to where the hoses now go onto the round oil tank.
The round tank seems to have 3 connections from the front of the tank, I beleive the middle to be the return line.
Can anyone shed any light for me as to what hose goes where from the oil pump??
Got me f*cked!
Dan
There you go
http://www.bikernet.com/garage/PageViewer.asp?PageID=384
hi, wash tank out clean & use new oil lines, when washing tank out you will see what one of the fittings is the feed to the oil pump because it will have fluid coming out . don't fill right up only about 1/2 to 2/3 full you should only have 1 feed the other are breather & return both of these should have return tubes set high in the tank above oil level as to dump return & the other to breathe oil tank thru engine breather , oil pump is easy , outside is in & inside fitting is out , the inside fitting on the pump is out or return thru oil filter or oil cooler to tank , the engine breather is at the back of crank case above the pump it is to let the oil tank breathe thru the engine main breather so when you fall of the bike it dosn't spill oil everywhere , if oil tank has 3 fittings on the bottom with-out 2 inner tubes extending up don't fit it check 1st , some oil tanks have 1 low feed fitting & 2 high in the tank for return & breather , cheers
after assemble best to take feed line off at pump untill oil comes out to help bleed the feed , as it's only gravity feed so no air lock ,
