Just fitted the new SE compensator to my 2007 Dyna. I have had noisey start up from new and intermitent hot start problems. S ...
C&R Engineering in Revesby. Did a 80in Evo to stock specs. I made enquiries of Robinsons as I had heard very good reports of the q ...
seen them C Lifters fail with only a coupla thousand K's on them
Had a drivetrain bearing noise for some time, eliminated wheel bearings, drive belt etc, am now replacing inner primary bearing, n ...
I just recently had a similar problem when I put my apes back on and it was a fuse blown...
Hi guys, I hope you can help. This could be a real dumb ass question... But here goes... I have 68 ironhead. With a springer front ...
Thx man
thats a 1983 Roadster , we have & original in blue, , 1974 was the best because it had the thicker barrels that went from 74 t ...
I have vance & hines 2 into 1 Tracker pipes with Thundermax AutoTune never had decel pop, had the pipes on for 4yrs and they s ...
good to hear mate
I use wildwood discs hawg halter calipers haven't had any issues
I went the Lyndal pads and braided lines and very happy.
I know its an old post but if they put the rear brake spacers on wrong it will bend the disc.
get a new bike greasy?
Man - They need to get TTS working on an iPad! It's a pain the arse to get the laptop out there.
box may need adjusting in side at the selector paws/or worn or clutch adjust if it only every now and then may be change to redlin ...
Or maybe they loaded the wrong map originally and didn't want to say it? Maybe, or maybe not..
If you have ever tried welding using an Oxy set, well the basic technique is the same, but you are using an arc to heat the parent ...
cheers nado. have gone down that path in the end. kudo's must go to ando for his help with this. must admit made me feel not so ...
have you tried Jaycar for spare bulbs?
