Thanks Guys, C= spanner, allen key and use the old torque gauge in the elbow. Done. Have a great day gents.
Thanks for your input. I would consider several cam sets. 54s, 222s or perhaps Tman torqster. GMR has a successful grind as well. ...
probley the fuel cap vents
2 minutes on full power in the microwave will do the job
bump
Amcn said we will only get the 500. No 750 for oz they reckon.
That's more or less what we will end up doing Soap Box ... there are actually little LEDS on the top part now under the tail light ...
Cv carb will compensate for altitude.
My light didn't come on the other day but I knew it was getting low because every time I gave it a bit of heavy throttle it sounde ...
the Dyna 2000i is not a very reliable ign unit be carfull
I know it an old post but Hartland (spelling may be wrong) sell a cam bearing install and removal tool a lot cheaper than the othe ...
The stutters bit of a bitch, happens when your service is crap. Deadwood, I'm interested. If you want to PM me, we can d ...
585's are available in chain or gear drive.Can also get easy starts or normal cam.
Well just the rear but i want it to match the front the guy i got it off said it would be better with a wide belt
http://www.calderpark.com.au/events.aspx Next friday there is one on, i wont be taking my bike out to race as we are most li ...
No waving down here in Vic.... We are 'nodders'.....lol
Cherers guys.... I'll downsize the pilot jet from a 48 to a 45 as I'm only about one and a quarter turns out on the adjuster screw ...
Good result mate. I'm sure you only kept the good junk.
I fabricated my own rack and had it powdercoated. I purchased the bag from Andy Strapz. There's plenty of room for an overnigh ...
I went to HD developments and was 30 for less that half a leter, ill call peter stevens. How do you gauge how full the master cyli ...
