From reading the above posts my guess would be swing arm or shocky bushes. It can be difficult to find movement in swing arm bu ...
Bugga that. Could have been worse though. You could have killed the bird! What sort of kit did you end up with? Any cams or headw ...
I've just finished bleeding mine after new line install. If you're want I can come over and help you. It takes about half an hour ...
You say at 14.6 you are running fat so it was changed to 13.6 and now it is OK ???? What !!! the bigger the number, 14.8 the le ...
Putting bigger pistons in the motor will make it have more power, but THERE IS NO SUBSTUTE FOR HEAD WORK. This is where the power ...
If the breather gear was installed improperly the bike would likely smoke and push oil out of the gaskets. Sounds like you had to ...
I tried ATF in my primary a few years ago and found it was a lot thinner than oil, and it started to seep around the gaskets a bit ...
Will check that out. The holes line up and the gaskets seem the same but i will check for any offset. Cheers
Great stuff I have moved the position with the wrench and you are right, it is a softer feel and seems to sit slightly lowe ...
Hi Markle, As above... keep your original pipes in case you have to do noise check someday... you will not regret that decision.. ...
Had a similar problem on my friends sporty.found out to be the ht leads where they plug in to the coil there was corrosion.try cle ...
New style injectors are made to be replaced, not repaired and cleaned, unless you are running a diesel engine.... Correct me if i ...
Metric
just whack this in, http://cgi.ebay.com.au/Harley-Davidson-96-cubic-inch-motor-/260740029551?pt=AU_Motorcycle_Parts_Accessories&h ...
thanks for your help fella's
Not sure it is as easy as just restricting it. I think you have to get it on the approved list which is porbably harder: http:/ ...
You won't be the first or the last to have bearings go at 16K. Mate had them go on his evo at 16K's also, so it's not a new thing ...
hi, i think james use's the MLS steel head gasket's cometic style now , these head gaskets have been improved upon sin ...
Probably wouldn't hurt to check/replace all your fuel lines and other hoses, with the vacume hose has perished and cracked the oth ...
Cheers Ultra, May have a play with that one once I've finished running in the new barrels.
.jpg?v=638937893478370000)
