the starter motor shown in the pics come with a deflector wether it is needed or not. i have fitted 4 or 5 of these starters and h ...
Kaboom, all that I wrote for our fuel tanks also applies for the servos, except the servos dump their crap into our tanks and char ...
Ha! Thanks Kingchops... never thought of that! I'm new to this caper and never knew there was such a thing as a dual element bu ...
Thanks, got the message finally!!! I'm on the darling downs anyone special I should talk to about doing this??
Ok! Hows this....... The 2011 Catalog my Aussie dealer gave me has a 'Screaming Eagle Street Performance Tuner' p/n 4100008 in it ...
you can stamp your old numbers across to new cases[hmmm] and say nothing. or you could go through the hassles of getting new numbe ...
I think I might have melted the unit, jus found 2 spots where I managed to pinch the rh indicator wire under the strut bolts. Yep ...
Are you using a custom Map, or the correct Aussie canned Map ?
turn ign to on to ignight icon lol
I've used shell v power for a couple of weeks with no problems.
Now they look nice, realy nice
check your linkages arnt a bit stiff and stopping the gear box armfrom fully returning between shifts.
Go for the burleigh bars.
Good stuff mate ! thanks for the answer to your problem.
I'd use 20w in the front forks. Amount you'll have to look it up.As for the rear increase the pre load to max.
Thanks Beeza I've replaced it $28.00 .
Oil on th engine mounts is not much of a problem if the oil is cleaned off within an hour or two. If engine oil does cause an engi ...
Have a look at nrhs performance site,they explain alot about lift,duration,timing,over-lap ect. selection & fitment.In for sale se ...
well bugger me I didn't see that thread. Thanks Dodgy
That chrome switch is expensive lol
.jpg?v=638937893478370000)
