Fitted with screaming eagle race tuner. 2008 Lowrider.
Thanks Hilly.
Pertthog thanks I'll have a look and fat bat I'm looking to build with Harley parts as I want to build a Harley chopper not just ...
i could answer any castiron sporty ques you like but best buy a factory manual 1st & then read it
so yep there you go was going to say yes as most 90s Harleys are the push in type weather it be the rubber type or the metal type ...
Got it thanks.... Any idea where I could locate the ball check valve? :-P
Have since been told that the 57h is the cam i should be looking at. It is an updated version of the 48
You're a legend, thanks very much mate. Will take that to the dealer Sat and get them to install it.
is it a spool hub??
Thanks for that mate !!!
.jpg?v=636380580467000000 "IMG_20140512_215330_(Medium).jpg")
.jpg?v=636380580467000000 "IMG_20140512_215955_(Medium).jpg")
.jpg?v=636380580467000000 "IMG_20140512_220045_(Medium).jpg")
I've gone with an s&s 106 kit, 583 cams, assembled by APL at Windsor who will be porting my original heads and doing an individual ...
Thanks for the replies guys, appreciated.
I've used the Altrex brand and also 3M brand. The Altrex was a lot thicker and harder to shape to the headlight, but would protec ...
6th Ha ha! I did notice it had lots of gears! As far as I know the cross bones is geared down compared to other models (but ...
Just got back from dropping my Iron off to T1 at AA Custom cycles for Hammer 1250 kit, Clutch upgrade, oil drive gear upgrade ...
Ando's already put it in, just saw a table with 2013 softail has a 25 mm belt, Main belt manufacturers or suppliers seem to be ...
paul check your PM
Thank you very much Bangkok Bob Kubkun krap Cheers, Supamit
have them in my bike, its what i asked for if ya gunna put bigger bumps in so ya can rev the clacka out of it get ya bottom end se ...
I'm not even sure if these are transferable, I did read they marry to you vin#. I might just wait a bit and get the FP3, it ...
