Wouldn't run anything else in any of my bikes. Change it once a year and it comes out the same as it went in. yep, it's aHD, the ...
good effort HH and thank for the pics. it seems the only way to go restricting the outlet I tried the quiet baffles on my Freedoms ...
Got the tyre fitted today and took bike for a good ride on the twistiest roads around here. Must say that I'm happy with it, s ...
Thanks HDNUT. Appreciate your reply
From the picture above, you are using the accessory wire (orange) to power up the light. Should be using the white (hi beam) and y ...
You need to go to the "ROW" - "Rest Of the World" link - this covers Australia.
cheers mate. found the problem. the wiring loom had seperated from the inside of fender and was laying on tyre, totally shredded t ...
I would fabricate or machine up something that looked neater and fit it. Its probably not needed but would give a bit more rigidit ...
I'm stillrunning stock ignition. Haven't got the funds for an after market ignition right now saving for a wedding. I was just thi ...
Thanks FLHuTChU
My s&s cams were less than $400 delivered from the states but yes the dollar was better then...
Great idea and don't look out of place. Well done.
I've used two different memory sticks. One worked fine the other intermittent . Try another stick and what Mickle said !
I need to remove my rear fender. Without sounding like a total koob..Easy or difficult any advice or vids. thanks in advance ...
Thanks Mate
.jpg?v=636380580706830000 "20140112_111527_(2).jpg")
If you have installed the new clutch plates,, adjusted clutch ,, installed correct amout of oil,, and buttoned up eve ...
i always check studs for any loose one no matter what engine it is esp the 4 inner one's
Cheers for that Hutch...I was a little confused there...Yep,I managed to get a wheel... Cheers...Sparra
Fatbat, yes get it dyno'd, hopefully you get a better result as I'm very happy with my 585's. 114 ft/lbs of tq, 100 @ 2250 rpm.. ...
Thanx Hilly, wealth of information mate.
