I had mine done for a couple of grand and that included a hi flow filter. Made a heap of difference.
I found it and it's the right label. Next time I am in at HC will get it followed up.
Dangerous get that fixed asap. They may have fucked the rubber grommet fitting the brake lever.
Rinehart in North Carolina wanted $225, M&M did it for $65, they done the Parts for the same price as Rinehart
Welcome!
welcome slug good to have another territorian on here.Probaly would have been better to put your post in the introductions se ...
sorry jim.. they took plenty on the ride.. someone should have some....
Still got this La pera Sorrento for 200mm wide arse softails. Best offer may well secure it coz im getting fed up tripping over it ...
always a good night at the Bros
Yeah Mate, a top night was had by all. The live entertainment provided by the locals was exceptional ! Gunna ...
If you switch the bike off and bolt with the fob in your pocket, they can't start the bike.
G'day Willo
Welcome Mick
yeah thanks men , its a 77 matching no's,30thou over ,2"pipes that i made with small mesh baffles with fully tunable electronic i ...
The Master Cylinder Cover screws are not done up to tight as well. if they are done to tightly the gaskets gets deformed and allo ...
BABE RAID 2012 Twist of the Wrist 7th - 10th September Registrations ...
Thanks for reply....But i tried him, more expensive than HD But thanks again
I hope this is what you are asking for. It is on my DIY page. Harley Davidson Wheel Alignment Made Simple PDF Dow ...
Nice rear tyre too. Someone's been having a bit of fun!
Cheers Dave
