I am just approaching 12,000 and still plenty there on my heritage.
Welcome
When I did my bottom end I used the original crank but I sent the whole lot to Ollie. The crank has been welded, trued and balance ...
Dont know if this is what you are after but. http://www.nightrider.com/biketech
Welcome
G'day and welcome Joe.
all the hard work in in end will be worth it
The Missing VIN is very common on 2004 and earlier bikes. The 2001 model year had no provision for the VIN to be stored in the ECM ...
Not sure if this will help you as it sounds like your baffle screw may have sheared off or the baffle may be broken but this is wh ...
Magilla does it every year. & a very nice Bloke and Bike.
When doing the sealed roller bearings in the back wheel, most important to fully seat the pulley side bearing first. Mak ...
Contact Details The home of VROD PERFORMANCE or TABPERFORMANCE AUSTRALIA is 14 Joslyn Drive, RESEARCH, Victoria, 3095 htt ...
Welcome
Hi all, i have decided to do my headers and see how they go. Thanks for the advice.
2J_Car_&_Bike_Show_Poster.pdf
Has anybody tried clear contact adhesive, you know like the shit mum used to cover our school books with? It would be easier ...
I remember Aaron at Hammer mentioned their dyno mule ran like a pig with the valve closed but didn't cross my mind your adjustment ...
the last concert i saw ozzy (black rain) he wasn`t doing so well to keep up, he even shot off for 20 mins to have a cuppa....befor ...
Here we go... Latest update. The ignition has shit itself, the coils are running too high 3.6 & 3.7 ohms. I need a new ignition ...
Dropped in here today defiantly worth a look over the weekend,dident know so many people don't work on Fridays !
