I have a 2014 Xl1200CA which comes standard with T Bars and risers (not sure what size they are). I have fitted forward cont ...
+1 For Matt @ ROSNAR. After several visits to HH Ringwood- From whom I bought the bike from- with dissapointing results, I went ...
Welcome to the Forum, Nice bike mate- Clean for'08!
Welcome- Nice ride mate, enjoy the forum.
Thought they may have been. I had a set on my King for a few years but as I've become "more mature" my crook elbows protested so I ...
Thanks for the reply mate hope your enjoying your bike. Ok no worries I might go and put down a deposit. Do you like the drag bars ...
Bump... don't forget folk, this is on this Sunday
Three of us purchased T-Shirts to support this charity poker run when we stayed at the pub on the Snowy Run. You may want ...
Hi ive just put the se mufflers on my 12 wg for a trip to sydney for work for 3 weeks and yep they were pretty quiet after vh slip ...
Steele 2350 kms on the dyna for the brass balls run easy
Don't mean to be a killjoy here but those bags look like they snuggle up pretty close to your exhaust pipe. Perhaps it is just ...
I enjoyed reading about both these bikes. I'd use the word 'inspirational' actually, particularly Basher's &# ...
Your right Mutley for the OP. However my response was to Phil's question, although don't know what year bike he has either
I'll third that. I've got Hagons on my FLHX for the same reason, "fat pricks". First set i got the springs werent heavy enough so ...
It actually has a vented cap now and I think the fuel is leaking out of the vent in the cap when it gets hot and the pressure buil ...
Great Stevo! Yes give it a good run before going to track, tell your friend who thinks you should have more HP from set up to g ...
Try this http://www.ebay.com.au/itm/Motorbike-Motorcycle-Static-Wheel-Balancer-Balancing-Tyre-Stand-Motor-Dirt-Bike-/11172473530 ...
On the old bike I wrapped mine in a towel at two in the morning, then ended up ripping the fucker off and pulling the battery. Yo ...
Seriously .. get a bike lift, a set of SAE sockets and bits, a service manual and never look back.
.........and what is your opinion now that you've been running them for a while?
