Latest comments

Years ago I had a hotted up XJR1300. And I thought I was king of my little dung heap. A bloke on a Rocket 3 pulled up next to me a ...

Check clearance on rubber, shim mount, check exhaust not touching frame, check head studs Put rubber grips and foot pegs on if do ...

Sounds like a lifter to me, you might be able to pick which one with a stethoscope or a big screwdriver placed on the tappet guide ...

That’s an old post hanging in there, like self. Wat a lovely looking bike, I seem to only see Baggers on the road these days ...

Or just download things from harley https://serviceinfo.harley-davidson.com/sip/content/document/view?viewLatest=true&id=1681 ...

Hi, they go really well, very smooth, plenty of power and a pleasure to ride. I built the black one in 1980, the red one in 1985 a ...

House of Horsepower used the 4 screws for some insurance holding the cast in insert in place, the left case was the same. They ver ...

Thanks crowster69 ... I will look into that one ... Cheers.

I saw it and thought I know that bike, it's a beauty.

"I'm sure a lot of us have bought a "good used - whatever it may be -" to find it totally stuffed." - guilty as charged.

Do you have the workshop and electrical diagnostic manual's for your bike? They would tell you how to properly diagnose the issue, ...

I've been screwing around with this all day today and I think the dash base is where the problem is, it looks like there's no powe ...

maybe he has found his gears a pissed off for an overdue ride.

Where are you located mate ?  Supertuner pro can be "unlocked" here in Australia. Deffo NOT a TTS dongle. email to TTS only ...

Is it even a fault code?  could be a version/firmware/partnumber

Thanks. Every thing is brand new - jackshaft - starter clutch and clutch shaft.  Gone back the original jackshaft. Will not b ...

Sorry mate , cant help you .  There is usually a couple of nerds that will explain the codes.You might have to wait a couple ...

G'day  guys  un regards  to the dash  lights  not working  I found  a circuit board  wizar ...

I have my trask tranny cover which ventilates the crank case(engine) with the filter mounted on the lower frame, Trask recommends ...

Thanks guys, I’ll start with the map I last installed and see how it runs. I’ve just done a full service on it, but now I’m thinki ...