Latest comments

Workshop manual, that would be nice! Thanks for the info guys. 

Think Mr. Tankslap is on an XS1-650 Yamaha  ?

thanks for the feedback Gents, gives me some homework to do.... cheers

Thank you very much for the heads up guys I end up going for a locally sourced Biltwell Frisco Handlebars - 1 inch - Black. I gues ...

Has anyone fitted a standalone rpm activated shift light (not a gear indicator) to a 14 on breakout.. ?? 

I did it on an older bike.  Take a look at my Kingchopster build here:https://www.hdforums.com.au/Thread/296949/1#296949I nev ...

Nice one, that two tone grey and black is great.

Hi guys I'm chasing the plug for the led light that goes on the tour pak, it's got 5 male pins, one on each corner and one in the ...

Thanks for the advice folks. Liking the Wild1 Chubbies and risers. Not sure about the forward controls at this stage as I quite li ...

Just got back from the Island today, did a decent loop from Canberra.The race was awesome as always but bloody cold at times.Good ...

I got the Sundowner solo for my 2012 sporty custom, because I couldn't source a Mustang wide touring locally. Couple of shops sold ...

RIP George.

Looking for spare front fender for iron 883 to be fitted into my 2016 iron 883. Ill repaint it so not fussed about surface ru ...

Hey guys just an personal point of view / review of Windbreaker unit ... got to try a demo unit for my 2017 Road Glide Special ... ...

Compression leg specs arrived at FYI. Pre-Rushmore (FLHX) . Reb leg is stock set-up.2120x312 crossover201816141312 pivot.All shims ...

Correct, they are pushing for a different demographic, the 20-40 yo bracket.speaking to a salesperson last week, they cannot move ...

Where are you located

Where are you located

Nice work Chopa,I don't go much on your choice of finger food though.............Roo.

I’m out at Kogan creek power station, I will pm u my phone number so I can get your address, I have 2012 FLHX like u