The guard was bare metal had to get paint out of USA because Harley Davidson are pricks and will not give out the paint codes. A ...
Dam bike not yet finished but about 30 more sleeps to go i reacon and will be keen then But have a great ride.
Get fark*ed... They asking guys to stip on the roadside incase they have any club tattoos? whats next boom gates and armed guards ...
MaxiBoy ... if you have the bucks and are going for the single PM Caliper , get the 13" rotor ... helps heaps over standard ... I ...
I had 10inch apes fitted from dealer new (09) and I'm trying to recall what they ended up charging me, have no record of being cha ...
a 1992 fattie could be a bit on the slow side , if it hasn't had anybody too wake her up, come out & h ...
Have ya noticed when your stopped at lights instead of people checking out the bike most won't even look def no eye conta ...
Welcome from another a sunny Coaster
Haha WTF your giving me an epileptic fit ;-)
I am just approaching 12,000 and still plenty there on my heritage.
Welcome
When I did my bottom end I used the original crank but I sent the whole lot to Ollie. The crank has been welded, trued and balance ...
Dont know if this is what you are after but. http://www.nightrider.com/biketech
Welcome
G'day and welcome Joe.
all the hard work in in end will be worth it
The Missing VIN is very common on 2004 and earlier bikes. The 2001 model year had no provision for the VIN to be stored in the ECM ...
Not sure if this will help you as it sounds like your baffle screw may have sheared off or the baffle may be broken but this is wh ...
Magilla does it every year. & a very nice Bloke and Bike.
When doing the sealed roller bearings in the back wheel, most important to fully seat the pulley side bearing first. Mak ...
