Open the software and after you load your map, look down the list on the right hand side, were the AFR,VE and spark tables a ...
Don't know anything about it but you might get something from thishttp://harleytechtalk.com/index.php?topic=100255.msg1219491#msg1 ...
Thanks mate I'll look for it
Rob i dont have the expertise to answer that question other than to say we have similar issues with standards regarding the certif ...
no but could be possible, just remember dyna swingarm held in the gear box housing not the frame ( rubber mount )
They run a waste spark system though, so it will be firing on the exhaust stroke as well. Still waiting on my coilpack from Americ ...
Hi Tussuck, Thanks for the advice. I may PM you if I have dramas. I'm a shade tree mechanic on a good day but I'm not a ...
VHT caliper paint. It comes in gloss colours and you cure it at 93 degrees C for one hour in your kitchen oven.Piss easy and very ...
some say with chases dyno, rear chain or belt drive, can cause that even tyre slip.with Engine Dyno different, fact is it look's g ...
Whoa, just saw this and read with interest. Thanks for your input it made a lot of sense. I'm torn apart between trumpet and fisht ...
Hi, my BIL confirmed the TSM he got was the correct model for his bike.It seems at some stage the wiring loom has been cut & p ...
+1 on this advice.I had my 2001 TC88 checked at 28k while having a service done and the tensioners had bugger all wear. It effects ...
Look up bungking in the USA they do them in stainless , shiftrods tabs and all sorts bits for bikes I have ...
you could fit a blocking diode to the low wire,current only passes on way,this will allow low beam to switch on but no current in ...
Copied info on Full featured tuners 100% correct.I used to prefer the TTS system over the Supertuner pro hardware and so ...
70623-06 is the part number you want for the ACR wiring harness. Google -J04210 for the instruction sheet. I think HD have a plug ...
Update on supplier. A few days after my OP I found a supplier in Lane Cove NSW. https://automotivesuperstore.com.au/mbl-v-tw ...
it's a good idea, to do a voltage check before you start bike, should have 12.5 - 13 , then keep volt meter hooked up & start ...
I got a set of tie down straps from MCA in Auburn. Just the normal hook on each end and pull the belt design - BUT - on the top en ...
