Latest comments

Folks. Just came across this video on YT for paintless dent removal. Bloke did a nice job on the tailgate of a Toyota 4WD. Worth a ...

Set gearbox oil level to centre of 'X' on dipstickSet primary oil height at 12mm BELOW the square notch at the bottom of the clutc ...

Quick check:Tools: hex keys, measured 1 litre container, oil-proof Loctite. Method: 1) start the bike and do a short war ...

Krash, have you ever noticed roughly how far ahead the use by date is?. Like is it several months or several years. The normal 4 l ...

Lock on evilbay you can get a threaded insert with a nut   Which you can use to replace The Oem one  

Got the Clymer Harley -Davidson Sportster Evolution 1986-1990 service .Repair. Maintenance workshop manual. It doesnt cover my 98. ...

What the hell is a vrod?  and simply undo the clamp to remove the cover, or if its a spring then slide it away.

A casual glance and you would think it was different horn, good job cobber, unobtrusive and effective.

Yep that’s statewides  head office have been there a few times over the years  if My local  bsc  doesn’t ...

Be aware that the black coated ones tend to change colour a bit Travis. I stuck with chrome and am very happy with the system. It ...

I've put a set of genuine HD forward control mounts on my Fatboy, but I now want to extend them further forward for more leg room. ...

Thanks bloodog, good advice. I did this and it seemed to my untrained eye that the only thing these wires connected to was the lig ...

yep, you are right, the VPN is the issuethanks mate

RMAC is right, the 259e (in riding) is a fairly late cam. Lined up against a tuned 110, the 110 will pull at the start but the 117 ...

I have a fair few manuals stored on USB, if you cant find anything let me know I may have something. 

i ended up welding a tab across and used an extension bar to hammer it outfrustration got the better of methanks for the input !my ...

Funny (expensive) story, that DH crank chewed out the rods very early, was sent back to the US and they rebuilt it under warranty. ...

Interesting tool Vic, not expensive so I may as well get one for future use. I gotta pull the fork this time to refill it etc but ...

Mate I've done a few by slotting the old bush with a 32TPI hacksaw and then just folding the cut-edge in with a small cold chisel. ...

Arrived today. Thanks again Steelo!