Does anyone know what steps I need to follow  to change the security code on a  2007 Street Bob as  I am stuck with the previous owner's code.   The manual I have is from the USA, don't know if this makes a difference or not but I have followed the relevant steps with no results.   Thanx

i kjnow scotty knows a fair bit of what u ask .Yer better of asking in the tech help forum he lives in there i believe

well i can only go by the 09 model but with the fob handy try this......
1, turn ignition key... ignition-off-ignition-off-ignition
2, press left turn signal 3 times.
3, press right signal 1 time.
odometer will display current pin number.
4, enter first digit of new pin by pressing left turn signal the number of times u want, eg, 2 presses for 2 etc.
5, press right turn signal 1 time. this will replace the first number.
6, carry on with remaining numbers 1 to 9 can be used but no 0.
7, when 5th number is recorded, turn ignition key off, before module rearms.....

these need to be done fairly quickly.

hope it helps
Davo

Probably not a good idea to put that in the public domain guys.
Bikes will start going missing.

I had a shitload of trouble doing this on my bike, but after much trial and error I found it was the first step (turn ignition key... ignition-off-ignition-off-ignition ) that was messing me up. I tried doing it quick, in between and slow...and one of them worked, but I can't remember which one

perhaps you were not holding your mouth right?

I did exactly as I was told. Carrot up the backside, eyes crossed and tongue out.