Pappa, open the cal, go to tuning set up, working, top bar at far right click on acr, toggle enable, save it.

Yep, had to get on the puta for tax stuff and seen his post haha

Thanks guys, I found it and enabled it, YeeHa. Now that I’m in Tuning Setup, Working I’ve noticed that the Temperature Management and Active Intake are disabled. As I don’t spend a lot of time idling I can leave the Temp Manage off, but can’t find any info on the Active Intake. Any ideas?

I Found this, so I'll leave the AIS disabled.

Yes, sorry I shoulda said. In the Tuning constants you toggle off the "Active air" and Active exhaust if they are not toggled off already.

Yo Pappa, how goes it mate? there are no dumb questions, fire away if you need to, pm me if you want to chat on the phone.

Hey Grease Monkey

Just dropped in on this thread. Thanks for starting PapaSmurf, and once again thanks Grase Monkey, and Retro. Has been a while since I smoothed my tune, as has been getting too much fuel of late, can smell it when stopped. I've been scratching my head today, and saw this, good shit. As Dyno $150 an hour, nah not today. Still have the old2012 Road Glide Tourer 103, V & H ovals and SE air cleaner with 204 cams . Had the 044sdH004.  but did not see 358scv002, will give that baby a go. 'Big bore' I ignore as don't know what it refers too. Thanks blokes .Sorry to drop in on ya Papa.

Hi all, well it’s time to run the tuner through the bike again as I’m getting a bit of decel pop.

Very good question PS

The latter, if you haven't changed anything since the cal was put in just reflash it to clear all the learned stuff, if it clears it up then start looking for what drove it south.

Thanks guys, I’ll start with the map I last installed and see how it runs. I’ve just done a full service on it, but now I’m thinking of changing my air filter system, so I’ll probably wait until after that’s installed.