No, because you don't hold it wide open at those rpm, like a brief dyno test. I'm not sure who the Aust agent for twin tech is now, but they should have the little interface box. The software will be available online. It's the same as the crane software I'm pretty sure, written by Chris Schroeder. I could be mistaken about that as I'm relying on my memory 🙂.Have you tried the bike with vac advance blocked off? 

Lean between 2k - 3.5k?

right size carby?

No I haven’t tried the vacuum advance blocked.

Good point and I’m not to sure about the carb size. Maybe a 45mm may be better. But the inside inlet manifold size is the same. Good info👍🏻Maybe someone else can answer this question more accurately.Lushy Hoody Speedzter?

A 42mm Mik will easily support over 100 Hp.

Thanks speedzter I’ll give you a shout when I’ve purchased the gear. And thanks so much for your input as well as Lushy Hoody etc..for helping me and demystifying my engine build issues😊

+1 on the 42mik. 

Btw , not suggesting you run with no vac adv, just for a test.

Hhmmm no worries thanks mate 👍🏻