Hi

Im trying to put new bars on my 09 rocker all is going well until this .....It has stumped me The way I see it I have to remove these two ends to be small enough to pass through the bars 

Hope you mob understand what I am asking
Thanks bloodog  

All those plugs can be pulled apart so they are just wires. I'd youtube it for ya, but I'm heading back out the door. If you haven't found it by the time I get back I'll go hunting for it. Make sure you draw a diagram of how the wires go back in (or pic with phone).

Check this one, not sure it's the right one:

 

https://www.youtube.com/watch?v=ZxrChXXkxo4

now to work out the other one 

This one is very good also      https://youtu.be/LjF8g9H0Zo4 

 

Sweet. I had a few bookmarked when I did my bars, but must have lost them all. Seems you've got it taken care of though.