Man I have the shits....

Have made some changes to my bike - one of the few remaining things left was to plug in my new TTS and flash a new calibration on.

Was intending to do some vtune runs over the weekend.

Bike is a 2007 fatboy.  I took off the plug to my diagnostic port and bugger me, it only has three pins (instead of four)!

Will this work or will I need to order a new diagnostic port and have it wired up?

I didn't have time to experiment with things tonight - that was tomorrow's plan.  I was called back to family duties on discovery of the below tonight plus I had the shits...

Thank christ it's ok then - thanks Hilly you have made my night!

@001 - 2004 and a very few early 2005 bikes had 4 pins, then 2005 and up have only 3 in th e4 pin connector for a J1850 system. The new 2011 and up CAN models have a 6 pin connector with all 6 pins in them.