Installed these buggas to FATBOB yesterday and did a couple Vtunes (TTS) as well.
This morning I attempted to do a couple more VTunes but the laptop kept freezin on me!
Was pretty happy with last map, so thought Fuckit! and ditched the putor and shit and just rode it down to Tathra and back.
Very happy with the cams performance, pulls like a MF out of the corners now! However, I am thinking that I may need the +4 degree advance cog.
Seems to be a bit flat up till around the 3-4000rpm mark( only guessin, no tacho!)
Must admit, I am a "fairly" aggressive rider thru the twisties........(quite a few sportsbike riders would agree...... but would probably try and pretend it never happened!!)....but I would like that torque down a little lower. Figure for the fairly low cost and ease of fitting, I'm gonna give the +4 a go.
Still looking at headwork options to suit the cams, but wanted to see 1st what the cams do on their own........pretty fucken good so far!!!
Burto, just my opinion, but the best bang for your buck if your a bit tight on $$ would be to leave the heads and go for a flat top 103 with an .030 head gasket. Would take you to around 9.25 corrected comp. Cost you around $800 all up.
