Hi All,

I am in a bit of a predicament here and not sure what to do.
I've just powdered fork lowers on my 08 Street Bob.
Just to be on a safe side, I've changed the fork seals when assembling forks back. I've followed the instructions outlined in a service manual precisely. I've used a little bit of grease on fork seals prior to driving them in. Also they did go in rally easy.

Now, I took my bike for it's first run and the oil is "spraying" out of fork seals. I am stunned. I have no idea what I've done wrong!!!
All seems to be assembled OK but the oil is leaking.

Any ideas? Any pitfalls that I might have overlooked?

Any advice would be much appreciated. I am going to pull forks apart again tonight, but what do I look for?

Thanks

Make sure the washers are under the oil seals which are lip down,
1.upper locating bush-2 washer-3 oilseal-4 clip-5 dust cover-6 chrome cover.
hope this helps

Hmm.
Had the seals installed the wrong way in. Didn't help that I had kids running around all over the place and being distracted.
All good now.

thanks
Vlad