Can anyone tell me how to get more engine data items in the main display area.  Is this information map dependant.  I have started using TQ205-002.

When I load the sample DBW map all the items and status bit information appears.  When I load my current Vtune file I dont get O2 voltages and many other items as well as no status bit information.

If I try to change Assign main items, the drop down list does not have the items I think should be there.  Anyone able to shed any light on this?

 

Thanks

 

Thanks for the info lonewolf. I will check it out - as well as read the manual.

Like Scotty said, the more info the Data Master is pulling off the Buss the slower it comes so it's not as accurate.

Again thanks for the information guys.
Previously I was reading one of Doc's comments about checking the O2 switching prior to VTune to make sure they were working correctly and decided I would try to find this information on a VTune file I had done that day without any success, but I know why now.

This better than an Xbox

Fr3d

There is a special data stream for 02 sensors that record just the info needed.